Shownotes
Getting clean, dimensionally accurate prints in PETG, ABS, ASA and nylon requires attacking moisture and flow rate together, not just copying PLA recipes.
In this episode you'll learn:
• ABS and ASA print at roughly 240°C to 260°C, keeping the melt liquid longer after retraction and worsening stringing.
• PETG, nylon, PA-CF, ABS and ASA are hygroscopic; absorbed water flashes to steam in the nozzle and sputters material during travel moves.
• In PrusaSlicer the flow control is called extrusion multiplier; in Bambu Studio and OrcaSlicer it is called flow ratio.
• Total flow equals the…
Website: feeds.printara3d.cz

